Division B
Section 9.1. General
Section 9.1. General Copy linkAdd bookmark
9.1.1. Application Copy linkAdd bookmark
9.1.1.1. Application Copy linkAdd bookmark
(1)The application of this Part shall be as described in Subsection 1.3.3. of Division A.
9.1.1.2. Signs Copy linkAdd bookmark
(1)Signs shall conform to the requirements in Section 3.15.
9.1.1.3. Self-Service Storage Buildings Copy linkAdd bookmark
(1)Self-service storage buildings shall conform to the requirements in Section 3.10.
9.1.1.4. Tents and Air-Supported Structures Copy linkAdd bookmark
(1)Tents shall conform to the requirements in Subsection 3.14.1.
(2)Air-supported structures shall conform to the requirements in Subsection 3.14.2.
9.1.1.5. Proximity to Existing Above Ground Electrical Conductors Copy linkAdd bookmark
(1)Where a building is constructed in close proximity to existing above ground electrical conductors, the requirements of Subsection 3.1.20. shall apply.
9.1.1.6. Food Premises Copy linkAdd bookmark
(1)The requirements of Subsection 3.7.6. apply to all food premises.
9.1.1.7. Radon Copy linkAdd bookmark
(1)In addition to all other requirements, a building in the following designated areas shall be designed and constructed so that the annual average concentration of radon 222 does not exceed 200 Bq/m3 of air and the annual average concentration of the short lived daughters of radon 222 does not exceed 0.02 working levels inside the building for,
(a)the City of Elliot Lake in the Territorial District of Algoma,
(b)the Township of Faraday in the County of Hastings, and
(c)the geographic Township of Hyman in the Territorial District of Sudbury.
9.1.1.8. Building in Flood Plains Copy linkAdd bookmark
(1)Buildings constructed on flood plains shall,
(a)be designed and constructed in accordance with good engineering practice to withstand anticipated vertical and horizontal hydrostatic pressures acting on the structure, and
(b)incorporate floodproofing measures that will preserve the integrity of exits and means of egress during times of flooding.
9.1.1.9. Site Assembled and Factory-Built Buildings (See Note A-9.1.1.9.) Copy linkAdd bookmark
(1)Except as provided in Sentence (2) and in Sentences 12.2.1.2.(1) and (2), a manufactured building is deemed to comply with this Code if it is designed and constructed in compliance with,
(a)CSA Z240.2.1, “Structural requirements for manufactured homes,” if the building is constructed in sections not wider than 4.88 m, or
(b)CSA A277, “Procedure for certification of prefabricated buildings, modules, and panels.”
(2)The requirements of this Code shall apply to,
(a)building components designed and constructed outside the place of manufacture, and
(b)site installation of such buildings.
9.1.1.10. Public Pools and Public Spas Copy linkAdd bookmark
(1)Public pools shall conform to the requirements of Section 3.11. and public spas shall conform to the requirements of Section 3.12.
9.1.1.11. Shelf and Rack Storage Systems Copy linkAdd bookmark
(1)Shelf and rack storage systems shall conform to the requirements of Section 3.16.